Where Lake Champlain meets the Adirondack Mountains

	Zodaic Recessed Valve Insert Installation Instructions
Models-Years	Hull ID plates	Zodiac Valves	Zod Sales/Service	Metal IC Valves	Oarlocks	Avon Valves

In our shop we use a modified tool; a socket wrench with slots ground into it for removing and replacing the valve insert.
Alternative would be long nose pliers.   Be careful not to break the + shaped bar.  

Valve tool	Valve insert

To insert the new part Z60055:
Tuck the diaphragm corners into the housing.  Insert and screw down firmly.

Then use a thin probe, screwdriver, stick to push down the tabs and release the diaphragm.

Never use any lubricant on these valves.

Recessed Valve Cap Types

Note two types of  cap. Early one has prongs. New one screws in
They are not interchangeable. Collars are the same.
Although a new collar is supplied, you should not change it unless broken or leaking;
just cut the old string and tie it to the new one.If you loosen the collar it may leak air.

If you remove it be sure not to drop the base into the tube or you are in real trouble!
For more valve information and links for ordering parts see our valve parts page.

Copyright ©2009 Westport Marina, Inc.

We offer detailed advice on do-it-yourself inflatable repairs.
Before buying a used inflatable, please be sure you know what you are getting into.
We get several inquiries a week from buyers of used "like new" inflatables that are very costly or impossible to repair!

Westport Marina on Lake Champlain
20 Washington Street   PO Box 410, Westport NY 12993-0410
(518) 962-4356 for general questions only; Specific part look-ups must be by e-mail.
We do not sell parts by phone order. Please use links above to order on line from ShipStore.com
E-mail questions to: TheCrew@WestportMarina.com

Updated 13 May 2009
Copyright © 2007/9 Westport Marina, Inc.
Design & Webmaster Bob Carroll